- This topic has 3 replies, 2 voices, and was last updated 2 years, 8 months ago by .
Viewing 4 posts - 1 through 4 (of 4 total)
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
Spread the love!
Community Home › Community › B-Hyve Indoor/Outdoor Timer › Controller Not following Set Interval
Unless it rains, my controller waters every day no matter what interval I set in the smart watering. The MAC address is 44:67:55:03:11:8C.
Hello ttbs922, i’m updating your firmware, so it should now follow any of your set watering restrictions. If it doesn’t try updating your Wi-Fi settings, and unplugging your timers ribbon cable for 5 seconds, and factory resetting your timer. Let me know if you need any other assistance.
I have tried everything you mention and it is still watering way more than it should be based upon the setup. Do you have any suggestions before I resort to returning this thing?
@ttbs922, Currently smart watering is set to start at about 6AM, with no other restrictions set. Currently all of your zones are set to water every Saturday for 20min, except your zone 4 which is scheduled to water for 15min. Your next scheduled watering is tomorrow Saturday for exactly described above. Then the next scheduled watering isn’t until the next week the same schedule. However your zones are split so some will water on Saturday, and the rest on Sunday. If you wish to adjust your watering schedule you will need to do so for each zone under watering schedule adjustments in the smart details page. Here you will be able to adjust the runtime and watering frequency for each zone.