- This topic has 3 replies, 2 voices, and was last updated 2 years, 6 months ago by .
Viewing 4 posts - 1 through 4 (of 4 total)
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
Spread the love!
Community Home › Community › B-Hyve Indoor/Outdoor Timer › I can't activate any of my programs
Tagged: Auto programs fail
I have been using my B-hyve for over a year but while trying to set it up this year I can’t activate any of my programs. If I go to Program and load an existing program and then activate it by selecting ON, it goes to On briefly then switches itself to Off. This happens with all three programs I have tried. At times I also get a message that says the program has been changed remotely do I want to Exit, Import, or ??? Activate. I tried all three but nothing changed. A little later I tried again and I can select a program and activate it and it stays on until I leave the program mode. If I check scheduled there is nothing scheduled. If I go to Home it says I have no programs scheduled. When I go back to Program all of the programs I activated are now Off.
I tried resetting the rain sensor by holding the Rain Delay button down on the controller for 5 seconds and it when to Off, but I still can’t make a program active
Hello Bault, Could I please have your devices mac address to take a closer look? Thanks.
My MAC is: 44:67:55:00:d0:70
Hello Bault, I’ve enabled your programs for you. You may want to unplug your timers ribbon cable (for about 5 seconds), and then update your timers Wi-Fi settings. This will help fix any app/timer connection issues that may have been going on. Please let us know if you have any other issues.