- This topic has 2 replies, 2 voices, and was last updated 2 years, 9 months ago by .
Viewing 3 posts - 1 through 3 (of 3 total)
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
Spread the love!
Community Home › Community › B-Hyve Indoor/Outdoor Timer › Program running at zero minutes >1m
Help. No matter what I did,every zone ou run for less than 1 min.
can u update my firmware
Stations: 12 (6 set up)
MAC Address: 44:67:55:01:50:D5
Firmware Version: 0031
Hardware Version: WT25-0001
Update Wi-Fi Settings
Your firmware has been updated to our latest version (32). There is a possibility that you are getting a false rain sensor signal, check the jumper wire between the two sensor terminals of the timer and make sure both are in securely, and you can turn of the rain sensor when the timer is in Auto by holding down the rain delay button for 5 seconds (the screen should then display SEnS OFF) if you are still experiencing problems after this please email us at [email protected]