- This topic has 0 replies, 1 voice, and was last updated 2 years, 1 month ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Spread the love!
Community Home › Community › B-Hyve Indoor/Outdoor Timer › Rain sensor contacts not working
I removed the jumper wire to install a rain sensor and the system did not see that the jumper was removed and produce a rain delay. I know there is a software switch that toggles on and off but am not sure what is supposed to be set at, on or off. In any case i tired it in both positions and still no rain delay, so i guess I might not put in the rain sensor switch, as it does not even delay when the jumper wire is removed. Any suggestions? If you want to look at my system, here is my mac address. 44:67:55:03:9E:C4. My firmware is #38