Community Home Community B-Hyve APP Forum Smart watering showing

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #1303
    bail9470
    Participant

    Previously my smart watering was scheduled and running fine. I had some bad wiring to two of my zones and re ran some of the wiring. Currently I am able to water each zone manually as well as remotely through my app. However, when I have smart watering turned on I get a message that the scheduled run time of 10 minutes per zone 2x was only run for <1 minute per zone.

    I contacted customer support previously and they said that it could be a bad wiring or solenoid problem. To me this doesnt make sense, because then I should have the issue if I ran the program manually and remotely with the app. So to me, it seems to only be an issue with the smart watering program schedule.

    My MAC address is 44:67:55:00:61:4F and firmware version is 0032. Hardware version is wt25-0001

    Spread the love!
    #1318
    Stephen
    Keymaster

    Hello Bail9470, have you checked the sensor terminal? Its possible you have an active rain sensor. Try holding down the rain delay button for about 3 seconds until the timer display says “SENS OFF”. Then try setting up a custom program for a few minutes ahead of your test time and see if it does the same thing.

    Spread the love!
    #1324
    bail9470
    Participant

    I have not tried this. I had an old rain sensor that I disconnected, but could have done it incorrectly. I will try this fix and see if it resolves the issue. Thank you.

    Spread the love!
    #1784
    bail9470
    Participant

    Just wanted so say thank you for the fix. I made the recommended change and it is working perfectly.

    Spread the love!
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.
Spread the love!