- This topic has 1 reply, 2 voices, and was last updated 2 years, 9 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
Spread the love!
Community Home › Community › B-Hyve Indoor/Outdoor Timer › Trouble with initial install
Tagged: Pump Fault
I was replacing a rainbird timer with this and I simply moved the zone wires from the old timer to the new timer. I have a pump on the system that runs on 24 v AC and I connected it to the pump and common. Had no issues connecting to blue tooth or wifi, but I am getting a pump fault. Current Firmware is DEBUG-010. The mac address is: 44:67:55:03:3b:c5 any help would be appreciated.
@BEAVERLAKE Your firmware has been updated to our latest version of 23 for your timer. If you continue to get a pump fault error then I would advise you to double-check your wiring from the timer to the pump (it should be connected to the pump and common terminals as you said) for any breaks or disconnects or else you may need to contact your pump manufacturer.