[beebee]

Up

2

Down

::

I could solve my problem described above, where before I could not add another hose faucet timer (HT25, generation 1) to my existing system of 4 HT25’s. What I did is to remove all the hose faucet timers which showed they were disconnected (4/5/) and added them back in with wifi connection (all in one go, not leaving the adding menu of the app). As expected, after a few seconds, they all showed their status as disconnected again. But what then solved the problem was a software reset of the HT1 hub (not cycling the power, but a soft reset in the app). Nothing happens, there is no feedback from the app that it did anything, but it was very satisfying to see the status symbols turning from red to green (= connected) one by one after the soft reset of the hub.

So for now, all my five hose faucet timers are up and running, hopefully at least during my vacation!

[beebee]

Up

0

Down

::

Same here. Everything worked for a while, but then it suddenly stops watering without any obvious reasons. Getting it back is a nightmare: connectivity issues, timer off mode, battery issues with fresh batteries installed repeatedly, etc. etc.

[beebee]

Up

1

Down

::

I have had one hub and four faucets for the first 2 years and everything worked fine. Trouble started when I tried adding a fifth faucet in the third year; this never worked and even messed up the previously working four faucets. I don’t have a solution, but the problem seems to be related to adding faucets to an existing system rather than a limit to a given number of faucets.

[Author]

Posts