Community Home Community B-hyve Connectivity

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #82378
    [email protected]
    Participant
    Points: 1
    Up
    0
    Down
    ::

    We have been using B.Hyve for some time and today the system will not run manually. When we go to a zone and select test and then select the time and press the tick the zone just reverts back to test. We have a separate little one tap system also and this will not water manually either.
    We have deleted and re-loaded the app, we have turned our phones off and we still are not able to get the system to run manually.
    Can anyone assist?
    Kind regards
    Susie

    #82382
    [email protected]
    Participant
    Points: 3
    First Time
    Up
    0
    Down
    ::

    Today, I’ve reconnected my system. The irrigation works manually just fine from the actual device. When I try to connect to it though, the bhyve app will NOT send any commands, including manual irrigation.
    I ended up resetting everything, restarting my entire network and still nothing, using a different wifi, a hotspot, 2 different phones including an Android.
    What used to happen after reset, is that I put the device in pairing mode, then I would connect to it succesfully via bluetooth, and then enrol it in the wifi network. All that seemed succesful, but the bhyve app WOULD NOT SEND ANY COMMAND to the device. After having a HELLISH day trying to sort this out, in the evening, it just started working.
    So I assume this was a server side issue from ORBIT, I just wish we’d get notified when stuff is down, because I had to reset EVERYTHING trying to solve the problem and that was all for nothing, and then spent 2 hours reconfiguring stuff…horrible

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.