Community Home Community B-hyve Underground Watering Programme Repeats

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #82041
    Hobie
    Participant
    Points: 1
    Up
    0
    Down
    ::

    Hi, I’ve just installed and programmed an ‘Easy-Set Logic 4 Station Timer’. This is a replacement of an older Orbit controller so I’m familiar with programming. I only use 2 stations, both using ‘A Program’ each for 30 minutes.
    Both stations operate as programmed however, when station 2 finishes as programmed, station 1 re-starts and the whole program repeats itself, probably infinitely until I turn the controller off. I have no visable settings in Programs B or C for either of the 2 stations – the screen for programs B and C are blank for each of the two stations.
    Obviously I have made a setting error somewhere and I would appreciate any suggestions as to how I can correct the current ‘repeat’ settings.
    Many thanks.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.