Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: Water flow rate #81487
    [email protected]
    Participant
    Points: 6
    First Time
    Up
    0
    Down
    ::

    TY! Tried what you suggested but don’t see “recalibrate“. My drippers are PC. The problem is that at the beginning of the cycle the flow rate is high. After about 3 minutes the flow rate flattens out. Ideally I’d like to recalibrate 5 minutes into the cycle. The drippers are for my backyard vineyard. When the water is on it’s on for 2-3 hours.

    in reply to: Water flow rate #81486
    [email protected]
    Participant
    Points: 6
    First Time
    Up
    0
    Down
    ::

    TY! Tried what you suggested but don’t see “recalibrate“. My drippers are PC. The problem is that at the beginning of the cycle the flow rate is high. After about 3 minutes the flow rate flattens out. Ideally I’d like to recalibrate 5 minutes into the cycle. The drippers are for my backyard vineyard. When the water is on it’s on for 2-3 hours.

    in reply to: Water flow rate #81485
    [email protected]
    Participant
    Points: 6
    First Time
    Up
    0
    Down
    ::

    Up
    0
    Down
    I set up my new hose timer today and everything went smoothly. At the other end of my hose are 104 0.5gph drippers so the flow rate should be 1.7 gpm (gpm, NOT gph). But my b-hyve says that the flow is double that. I’d like the b-hyve reset the flow rate. Is that possible?

Viewing 3 posts - 1 through 3 (of 3 total)