There can be a few different possible causes when this issue occurs. First, we need to be sure the sprinkler wire from the valve(s) is fully inserted in the terminal. You will want to remove the wire and reinsert it. If your terminal uses screws, please make sure they’re tightened. To ensure the wiring is…Read More »
Tag Archives: pump
My station won’t turn on. How to troubleshoot a valve There are a few different possible causes of your stations not turning on. Your water may not be turned on. If you have a master valve, manually open that and then try running the timer again. If you have a pump, make sure that is…Read More »
Many systems will have a master valve or a pump that needs to be turned on to allow the water to get to your valves. You should have two wires coming off of this valve/relay. One wire will go to the terminal labeled Pump, and the other wire will go into the common (C). Note: Any…Read More »
Our relay is an “open circuit” electric switch that is used to connect high voltage (120/240 VAC) from a high voltage source to a pump or other high voltage circuit. The relay/switch is operated (turned on) by connecting a 24 VAC source to the two blue wires connected to the relay coil. Most timers do…Read More »