Our Orbit pressure-regulated sprinklers have a date code that indicates when the sprinklers were made and tested. The marking can be found on the bottom of the sprinkler and consists of two numbers on either side of an arrow that indicates the year. The arrow points to the month and is shown as numbers, corresponding…Read More »
Tag Archives: sprinkler
Water pressure can cause issues with the irrigation system depending on if it is too high or too low. If the water pressure is too low, it could cause the sprinklers to not water the correct distance, or some sprinklers to not water depending on how many heads you have attached to the zone. If…Read More »
If you are using the Orbit Sprinkler System Designer and want to move one of the sprinkler heads to a different location, then you would likely need to make that adjustment in person as there is no way to manually move them using the designer. If you think that the placement of the sprinkler heads…Read More »
How many sprinklers can I have on a zone or station? This is determined by several variables: Static water pressure, service line size, and the flow rate of each head or sprinkler that will be used on each zone. How deep do I bury the gear drives, pop-up impacts, or spring-loaded pop-ups? Install at ground…Read More »
If you are looking for help with adjusting your Orbit sprinkler heads, or perhaps some other information then this article should help. Voyager II Saturn III Saturn IV Impact sprinklers Orbit Titan Gear Drive Pop-Up Sprinklers Back to Support pageTags: core, impact, pop up, saturn, sprinkler, troubleshooting, voyager
In the B-hyve App, you are able to select one of three different options under a zones details. This will help with making sure that if you choose to use smart watering, then the smart watering programs will be accurate. The three types are SPRAY, ROTOR, and DRIP. To access this feature from the home page select the “Zones” section…Read More »