If your timer is showing the “Battery Low” symbol all the time, use these steps to troubleshoot the issues. (The Low Battery Symbol should appear near the top right of the screen on the timer, to the left of where the time is displayed) Underground timers and B-hyve Indoor/Outdoor Timer it’s possible you simply have…Read More »
Tag Archives: Troubleshooting
If you’re experiencing an issue with the button(s) not working on your Orbit device, then this article can help with troubleshooting. We’d like to have you try power cycling the Orbit device. Half the time, a simple power cycle of the device will help address this issue. To do this, unplug your device for 10-15…Read More »
Here is a guide to troubleshooting your system when the sprinklers aren’t turning on, even though the timer says they’re running. There can be a few different possible causes when this issue occurs. First, we need to be sure the sprinkler wire from the valve(s) is fully inserted in the terminal. You will want to…Read More »
This article will show a 2 Outlet Hose Faucet Timer, but these steps will work for any of our hose timers. Leaking/ Will Not Close Troubleshooting Before we get started, here are a couple of very important tips when using and caring for your timer. ***It is important to remember to make sure your Timer…Read More »
Does your timer have no display? Let’s do some troubleshooting. Always make sure that: Remove the battery tray by squeezing the tabs on each side of the battery tray and pulling. Also, don’t forget to push the tray back in tightly and as far as it will go when done. Remember, the tray needs to…Read More »
Water is leaking from joints Check if: Connections and swivel couplings are tight. Washer is missing, pinched, or damaged and replace if needed. Sprinkler won’t activate Check if: Operation dial is set to appropriate time of day. Valve cable is connected to sensor unit. Batteries are low and replace if needed. Hose faucet is on….Read More »
Here is a video on how to replace the diaphragm inside a valve. Each valve has it’s own diaphragm. You will need to match the model of the diaphragm with the model of the valve. Here is a video on how to replace the solenoid on a valve Most solenoids on Orbit valves are interchangeable….Read More »
There can be a few different possible causes when this issue occurs. First, we need to be sure the sprinkler wire from the valve(s) is fully inserted in the terminal. You will want to remove the wire and reinsert it. If your terminal uses screws, please make sure they’re tightened. To ensure the wiring is…Read More »
The “No AC” message means there is no electrical power flowing to the B-hyve device, which could be due to no connection, a bad connection or a power outage. If you know the rest of your home is receiving power, then we can cross power outages off our possible cause list and move on to…Read More »
If your B-hyve Device is not keeping time, using an incorrect time or your programs are turning on at random times, then this article should help with that. There can be a few steps that can help address this issue. First, we’d recommend power cycling the B-hyve device. To power cycle, simply unplug the device…Read More »