How many sprinklers can I have on a zone or station? This is determined by several variables: Static water pressure, service line size, and the flow rate of each head or sprinkler that will be used on each zone. How deep do I bury the gear drives, pop-up impacts, or spring-loaded pop-ups? Install at ground…Read More »
Author Archives: josh
If you are looking for help with adjusting your Orbit sprinkler heads, or perhaps some other information then this article should help. Voyager II Saturn III Saturn IV Impact sprinklers Orbit Titan Gear Drive Back to Support pageTags: sprinkler, sprinkler-heads, troubleshooting, videos
If you are looking for instructions on programming your Orbit 7-Day Programmable Thermostat, then this article should help with getting everything set up. Initial Setup Slide MODE switch to OFF While holding the RESET button press SET, “offset” will appear on the display. Note: Do not hold the reset button for more than five seconds. Press the buttons quickly, one…Read More »
If you are running into any issues while using your Orbit thermostat, then this article has troubleshooting steps for issues we expect to see, and should be able to help. If your thermostat wires are not labeled and you have no way to find out which wire is which, then we recommend contacting an HVAC…Read More »
Want to take full advantage of your underground sprinkler timer? This may be the guide for you. What are stations and zones? A station or zone refers to a group of sprinklers attached to the same valve. Your timer will turn on the valve to let water flow to the sprinklers in that zone/station. The…Read More »
Calendar Page The calendar allows you to see both when and where your timer will water and when and where it has already watered. Details such as which zone(s) and how long each zone was watered, soil moisture levels, and rainfall are all available. Watering Forecast Go to the calendar, select a day in the…Read More »
Devices Page The Device Page will show you every Device you have on your account, the MAC ID of those devices, and the status of each timer. If you were to tap on a device, it’ll take you to the device detail page. Here, there are quite a few things you can do with your…Read More »
Welcome to B-hyve Advanced Settings. This is the perfect place to learn how Smart Watering works, discover ways to save even more water, and achieve the best possible results for your landscape. Most of the Advanced Settings can be changed using the standard Smart Watering Settings, but two settings – Efficiency and Management Allowed Depletion…Read More »
END USER LICENSE AGREEMENT By accessing and using the software (“Product Software”) that is embedded on the Orbit product (“Product”), you agree to the terms of this End User License Agreement (“EULA”) between you and Orbit Irrigation Products, Inc. (“Orbit” or “we”). IF YOU DO NOT AGREE WITH AND ACCEPT THE TERMS OF THIS EULA,…Read More »
Notifications will alert you of the following events: a rain delay is set a rain delay is suggested watering has completed there is a freeze warning there has been a timer fault your device has been set to OFF Notifications are set and sent based on the account you are currently logged in to, regardless…Read More »